;
;  gpx.ini 
;
; gcode to x3g conversion configuration file
;

;************ POST PROCESSING OPTIONS ************

[printer]

; MACHINE TYPE
;
; specify the machine definition using a pre-defined built-in type identifier
;
; NOTE: settings are order dependnet, so always start by settng the machine type
;
;	c3  = Cupcake Gen3 XYZ, Mk5/6 + Gen4 Extruder
;	c4  = Cupcake Gen4 XYZ, Mk5/6 + Gen4 Extruder
;	cp4 = Cupcake Pololu XYZ, Mk5/6 + Gen4 Extruder
;	cpp = Cupcake Pololu XYZ, Mk5/6 + Pololu Extruder
;	t6  = TOM Mk6 - single extruder
;	t7  = TOM Mk7 - single extruder
;	t7d = TOM Mk7 - dual extruder
;	r1  = Replicator 1 - single extruder
;	r1d = Replicator 1 - dual extruder
;	r2  = Replicator 2 (default config)
;	r2h = Replicator 2 with HBP
;	r2x = Replicator 2X

machine_type=r2

; GCODE FLAVOR
;
; specify the gcode flavor
;
; reprap = M109 Set Extruder Temperature and Wait
; makerbot = M109 Set Build Platform Temperature (Same as M140)

gcode_flavor=reprap


; BUILD TEMPERATURE
;
; override the gcode build plate temperature
; 0 = disabled

build_platform_temperature=0


; BUILD PROGRESS
;
; generate gcode for the build progress
; this should be enabled for slic3r and kisslicer
; 1 = enabled
; 0 = disabled

build_progress=1


; DITTO PRINTING
;
; print simultaniously with both nozzles 
; 1 = enabled
; 0 = disabled

ditto_printing=0


; FILAMENT DIAMETER
;
; set this to the filament diameter setting used in the slicer
; 1.75 = default

slicer_filament_diameter=1.75


; SD CARD PATH
;
; if an SD card is inserted the x3g file will be written there
; uncomment to enable and substitute the name of your SD card volume

;sd_card_path=/Volumes/Things/


;************ RIGHT EXTRUDER ************

[right]

; ACTUAL FILAMENT DIAMETER
;
; override gcode for the right filament diameter
; 1.75 = default
; 0 = disabled

actual_filament_diameter=0


; ACTIVE TEMPERATURE
;
; override gcode for the right active temperature
; 0 = disabled

active_temperature=0 


; STANDBY TEMPERATURE
;
; override gcode for the right standby temperature
; 0 = disabled

standby_temperature=0 


;************ LEFT EXTRUDER ************

[left]

; ACTUAL FILAMENT DIAMETER
;
; override gcode for the left filament diameter
; 1.75 = default
; 0 = disabled

actual_filament_diameter=0


; ACTIVE TEMPERATURE
;
; override gcode for the left active temperature
; 0 = disabled

active_temperature=0 

; STANDBY TEMPERATURE
;
; override gcode for the left standby temperature
; 0 = disabled

standby_temperature=0