Bugfix: first layer extrusion width wasn't affecting infill. Includes regression test. #2042

lib/Slic3r/Fill.pm

@@ -207,6 +207,7 @@ sub make_fill {
             $h,
             $is_bridge,
             $layerm->id == 0,
+            undef,
             $layerm->object,
         );
         

t/flow.t

@@ -0,0 +1,41 @@
+use Test::More tests => 1;
+use strict;
+use warnings;
+
+BEGIN {
+    use FindBin;
+    use lib "$FindBin::Bin/../lib";
+}
+
+use List::Util qw(first sum);
+use Slic3r;
+use Slic3r::Geometry qw(scale);
+use Slic3r::Test;
+
+{
+    my $config = Slic3r::Config->new_from_defaults;
+    $config->set('skirts', 1);
+    $config->set('brim_width', 2);
+    $config->set('perimeters', 3);
+    $config->set('fill_density', 0.4);
+    $config->set('bottom_solid_layers', 1);
+    $config->set('first_layer_extrusion_width', 2);
+    $config->set('first_layer_height', '100%');
+    
+    my $print = Slic3r::Test::init_print('20mm_cube', config => $config);
+    my @E_per_mm = ();
+    Slic3r::GCode::Reader->new->parse(my $gcode = Slic3r::Test::gcode($print), sub {
+        my ($self, $cmd, $args, $info) = @_;
+        
+        if ($self->Z == $config->layer_height) {  # only consider first layer
+            if ($info->{extruding} && $info->{dist_XY} > 0) {
+                push @E_per_mm, $info->{dist_E} / $info->{dist_XY};
+            }
+        }
+    });
+    my $E_per_mm_avg = sum(@E_per_mm) / @E_per_mm;
+    ok !(defined first { abs($_ - $E_per_mm_avg) > 0.01 } @E_per_mm),
+        'first_layer_extrusion_width applies to everything on first layer';
+}
+
+__END__