When we're appending a block to a directory file or the journal file,
and the new block is part of a cluster that has already been allocated
to the file (implied cluster allocation), don't update the bitmap or
the summary counts because that was performed when the cluster was
allocated.
Reviewed-by: Zheng Liu <wenqing.lz@taobao.com>
Signed-off-by: Darrick J. Wong <darrick.wong@oracle.com>
Signed-off-by: "Theodore Ts'o" <tytso@mit.edu>
Fix up a few places where we ignore return values.
Signed-off-by: Darrick J. Wong <darrick.wong@oracle.com>
Signed-off-by: "Theodore Ts'o" <tytso@mit.edu>
For each site where we test for a large file (> 2GB) and set the
LARGE_FILE feature, use a helper function to make the size test
consistent with the test that's in e2fsck. This fixes the fsck
complaints when we try to create a 2GB journal (not so hard with 64k
block size) and fixes the incorrect test in fileio.c.
Reviewed-by: Zheng Liu <wenqing.lz@taobao.com>
Signed-off-by: Darrick J. Wong <darrick.wong@oracle.com>
Signed-off-by: "Theodore Ts'o" <tytso@mit.edu>
There are a number of places where we multiply a dgrp_t with
s_blocks_per_group expecting that we will get a blk64_t. This
requires a cast, or using the convenience function
ext2fs_group_first_block2().
This audit was suggested by Eric Sandeen.
Signed-off-by: "Theodore Ts'o" <tytso@mit.edu>
Reviewed-by: Eric Sandeen <sandeen@redhat.com>
The ext2fs_add_journal_inode() function calls
ext2fs_check_mount_point(), which can fail if /etc/mtab is missing.
This causes mke2fs to fail in the middle of the file system format
process; mke2fs calls ext2fs_check_mount_point() already (and has
appropriate fallbacks that calls fails), so add a flag so that mke2fs
can request ext2fs_add_journal_inode() to skip trying to call
e2fsck_check_mount_point().
Addresses-Sourceforge-Bug: #3509398
Signed-off-by: "Theodore Ts'o" <tytso@mit.edu>
The DEFS line in MCONFIG had gotten so long that it exceeded 4k, and
this was starting to cause some tools heartburn. It also made "make
V=1" almost useless, since trying to following the individual commands
run by make was lost in the noise of all of the defines.
So fix this by putting the configure-generated defines in lib/config.h
and the directory pathnames to lib/dirpaths.h.
In addition, clean up some vestigal defines in configure.in and in the
Makefiles to further shorten the cc command lines.
Signed-off-by: "Theodore Ts'o" <tytso@mit.edu>
Add the ability to skip zeroing journal blocks on disk. This can
significantly speed up mke2fs with large journals. At worst the
uninitialized journal is only a very short-term risk (if at all),
because the journal will be overwritten on any new filesystem as
soon as any significant amount of data is written to disk, and
the new journal TID would need to match the offset/TID of an old
commit block still left on disk.
Signed-off-by: Andreas Dilger <adilger@whamcloud.com>
Signed-off-by: Theodore Ts'o <tytso@mit.edu>
The write_journal_inode() code is only setting the low 32-bit i_size
for the journal size, even though it is possible to specify a journal
up to 10M blocks in size. Trying to create a journal larger than 2GB
will succeed, but an immediate e2fsck would fail. Store i_size_high
for the journal inode when creating it, and load it upon access.
Use s_jnl_blocks[15] to store the journal i_size_high backup. This
field is currently unused, as EXT2_N_BLOCKS is 15, so it is using
s_jnl_blocks[0..14], and i_size is in s_jnl_blocks[16].
Rename the "size" argument "num_blocks" for the journal creation functions
to clarify this parameter is in units of filesystem blocks and not bytes.
Signed-off-by: Andreas Dilger <adilger@whamcloud.com>
Signed-off-by: Theodore Ts'o <tytso@mit.edu>
Teach ext2fs_expand_dir() and ext2fs_add_journal_inode() about
allocating blocks when clustered allocation is enabled.
Signed-off-by: "Theodore Ts'o" <tytso@mit.edu>
ext2fs_zero_block2() allocates static buffer if needed so it
should be freed at last (call it again with 0 args).
Signed-off-by: Namhyung Kim <namhyung@gmail.com>
Signed-off-by: Theodore Ts'o <tytso@mit.edu>
The top-level COPYING file states that the e2p and ext2fs libraries
are available under the LGPLv2. The files were incorrectly labelled.
Alex Thomas/Luster has been consulted wrt to the ext3_extents.h file;
the rest of the files were primarily authored by Theodore Ts'o.
Signed-off-by: "Theodore Ts'o" <tytso@mit.edu>
For filesystms that have the extent feature enabled, we need to grab
the use EXT2_IOC_GETFLAGS so that we don't accidentally end up trying
to request clearing the EXT2_EXTENT_FL, which is not supported and
causes the tune2fs -j error out.
Also fix the error returning in ext2fs_add_journal_inode() so it
returns a proper error code if the fstat() or ioctl() calls fail.
Addresses-Launchpad-bug: #416648
Signed-off-by: "Theodore Ts'o" <tytso@mit.edu>
I noticed that neither the journal nor resize inodes have
i_extra_isize set post-mkfs; while this isn't likely
to be a big problem, I think the below patch tidies
it up.
Signed-off-by: Eric Sandeen <sandeen@redhat.com>
Signed-off-by: Theodore Ts'o <tytso@mit.edu>
Added 64-bit mkjournal.c interface. Needed to zero inode tables.
Signed-off-by: Jose R. Santos <jrs@us.ibm.com>
Signed-off-by: "Theodore Ts'o" <tytso@mit.edu>
If the number of block groups is greater than half the flex_bg size,
the journal we be placed in the flex_bg super-group which is closest
to the mid-point of the filesystem, and in the first free block group
beyond where the metadata for the flex_bg is stored.
Signed-off-by: "Theodore Ts'o" <tytso@mit.edu>
This speeds up access to the journal by eliminating worst-case seeks
from one end of the disk to another, which can be quite common in very
fsync-intensive workloads if the file is located near the end of the
disk, and the journal is located the beginning of the disk.
In addition, this can help eliminate journal fragmentation when
flex_bg is enabled, since the first block group has a large amount of
metadata.
Signed-off-by: "Theodore Ts'o" <tytso@mit.edu>
This could cause certain mke2fs feature combinations to result in the
initial blocks of the inode table getting wiped out when the journal
is created.
Signed-off-by: "Theodore Ts'o" <tytso@mit.edu>
Add a new function ext2fs_zero_blocks(), and use it so that journal
data blocks is written in larger chunks to speed up the creation of
the journal.
Signed-off-by: "Theodore Ts'o" <tytso@mit.edu>
If the filesystem is opened in exclusive mode, then device will be
busy by definition, so don't return -EBUSY. This caused mke2fs -j to
fail on the 1.39-WIP (29-Mar-2006) release. (Addresses Debian Bug:
#360652)
Signed-off-by: "Theodore Ts'o" <tytso@mit.edu>
If fs->now is non-zero, use that as the time instead of the system
time when setting various filesystem fields (last modified time, last
write time, etc.)
Signed-off-by: "Theodore Ts'o" <tytso@mit.edu>
In ext2fs_add_journal_inode() check for the case where the filesystem
appears to be unmounted, but the device is still apparently busy.
This can happen when the luser doesn't bother to mount /proc and has a
bogus /etc/mtab, but still wants to mount the filesystem before using
tune2fs(?!?). Add a safety check to save him from his own stupidity,
at least on 2.6 kernels. (Addresses Debian Bug #319002)
Signed-off-by: "Theodore Ts'o" <tytso@mit.edu>
superblock. E2fsck will automatically save the journal information
in the superblock if it is not there already, and will use it if the
journal inode appears to be corrupted. ext2fs_add_journal_inode()
will also save the backup information, so that new filesystems
created by mke2fs and filesystems that have journals added via
tune2fs will also have journal location written to the superblock as
well. Debugfs's logdump command has been enhanced so that it can
use the journal information in the superblock.
The debugfs man page has been improved to more fully describe the
logdump command.
Added two new functions, ext2fs_file_open2() and
ext2fs_inode_io_intern2() which take a pointer to an inode structure;
this is needed so that e2fsck and debugfs can synthesize a
fake journal inode and use it to access the journal.
Add support for a new flag, DIRENT_FLAG_INCLUDE_REMOVED,
which will return deleted directory entries.
ext2fs_dir_iterate2 takes a new callback function which
is identical with the one used by
ext2fs_dblist_dir_iterate(). If the directory entry is
deleted, the callback function will be called with the
entry paraemter set to DIRENT_DELETED_FILE.
Makefile.in, alloc_stats.c (ext2fs_inode_alloc_stats,
ext2fs_block_alloc_stats): New functions which update
block/inode allocation statistics in the bitmaps, block
group descriptors, and superblock.
mkjournal.c (mkjournal_proc), mkdir.c (ext2fs_mkdir),
expanddir.c (expand_dir_proc), bb_inode.c
(clear_bad_block_proc, set_bad_block_proc,
ext2fs_update_bb_inode), alloc.c (ext2fs_alloc_block):
Update to use new block/inode allocation statistics.
file on adding a journal to an already-mounted filesystem,
try to clear the ext2 file attributes on an already
existing .journal file so that we don't fail if on a
partially added journal to the filesystem.